Skip to content
    See All Results
    < All Topics

    Allow Siemens PLC (1200/1500) to communicate with Experior through TIA

    PostedNovember 5, 2021
    UpdatedNovember 5, 2021
    ByKasper Vestrup

    If you are using a Siemens 1200 or 1500 series PLC, you will need to grant Experior full access through TIA.

    1. Open project in TIA
    2. Go to PLC properties
    3. Under General tab select Protection
    4. Make sure Full Access is selected as shown in the figure
    5. Check Permit access with PUT/GET communication from remote partner as shown in the figure below
    Was this article helpful?
    How can we improve this article?
    Please submit the reason for your vote so that we can improve the article.